Table of Contents
Advertisement
The camera is supplied
with the viewfinder
unit and cable attached
to the camera.
• Check that the viewfinder
cable is firmly attached
to the camcorder.
* Remove the protective
rubber fiom around the locking screw.
]
You can slide the viewfinder
unit along the bracket
.__ to a position that best suits you -- for use with
either the left or right eye.
_-
1. Loosen
the locking
screw
and
slide the
o
a.
unit
to the position
you require
along
the
bracket.
2. Tighten
the locking
screw.
3. Switch
the eye cup around
(if necessary).
• Slide and hold the release lever on the
underside
of the viewfinder
and then twist the
eye cup counter-clockwise
(until the mark on
the eye cup lines up with the mark on the
viewfinder)
to allow you to remove
it fiom
the viewfinder.
Replace,
with the eye cup
facing the opposite
direction,
by lining up the
marks and twisting
the cup clockwise
until it
locks into place.
10
Advertisement
Table of Contents
