Canon POWERSHOT D20 User Manual page 84

Using an Eye-Fi Card
Choosing _ mode will interrupt the Eye=Fi connection. Atthough the Eye-Fi
connection wilt be restored after you choose another shooting mode or enter
Playback mode, the camera may transfer any movies made in _&_ mode again.
CheckEng Cennect_en lnfermat_en
Check the access point SSID used by the Eye=Fi card or the connection
status, as needed.
Press the
MENU
button, choose [Eye=Fi
Settings] on the _'T tab, and then press the
@ button.
Choose [Connection info], and then press the
@ button.
The connection information screen is
displayed.
_ Disabling Eye-F_
Transfer
Configure the setting as follows to disable Eye-Fi transfer by the card, if
necessary.
Choose [Disable] in [Eye-Fi trans.].
Press the MENU button, choose [Eye=Fi
Settings] on the ?T tab, and then press the
button.
Choose [Eye=Fi trans.], and then choose
[Disable].
(_ [Eye=Fi Settings] is not shown unless an Eye=Fi card is in the camera
with its write=protect tab in the unlocked position. For this reason, you
cannot change settings for an inserted Eye-Fi card if the write=protect
tab is in the locked position.
191