Table of Contents
Advertisement
4-way Air Discharge Cassette Type
3
Procedure
Using temp. setup
No. [
].
4
Procedure
Using timer time
[
].
5
Procedure
Push
button. When the display changes from
flashing to lit, the setup is completed.
• To change settings of another indoor unit, repeat
from Procedure
• To change other settings of the selected indoor unit,
repeat from Procedure
Use
button to clear the settings.
To make settings after
from Procedure
6
Procedure
When settings have been completed, push
to determine the settings.
When
button is pushed, "SETTING" flashes and
then the display content disappears and the air
conditioner enters the normal stop mode.
(While "SETTING" is flashing, no operation of the
remote control is accepted.)
Installing indoor unit on high
ceiling
When an indoor unit is installed on a ceiling higher than
the standard height, make the high-ceiling setting for
fan speed adjustment.
Follow to the basic operation procedure
1
2
3
4
→
→
→
(
• For the CODE No. in Procedure
• Select the setting data for Procedure
"Height list of ceiling possible to be installed" table on
page 7 in this manual.
23-EN
/
buttons, specify CODE
/
buttons, select SET DATA
2
.
3
.
button was pushed, repeat
2
.
5
6
→
→
).
3
, specify [5d].
4
from the
Using wireless remote control
Change the high-ceiling settings with the DIP switch on
the receiver section P.C. board.
For details, refer to the manual of the wireless remote
controller kit. The settings can also be changed with
the switch on the indoor microcomputer P.C. board.
* However, once the setting is changed, setting to
0001 or 0003 is possible but setting to 0000 requires
a setting data change to 0000 using the wired remote
control (sold separately) with the normal switch
setting (factory default).
button
Setup data
0000
(Factory default)
0001
0003
Restore the factory default
To return the DIP switch settings to the factory default,
set SW501-1 and SW501-2 to OFF, connect a
separately sold wired remote control, and then set the
data of CODE No. [5d] to "0000".
– 23 –
Installation Manual
SW501-1
SW501-2
MCU(IC501)
SW501-1
SW501-2
OFF
OFF
ON
OFF
OFF
ON
Advertisement
Table of Contents
