Epson 400 User Manual page 112

c
Caution:
Once you remove an ink cartridge, it becomes unusable and
cannot be reinstalled even if ink remains.
1. Make sure the printer is on, then open the printer cover.
2. Hold down the
print head moves to the replace position. The
light begins flashing.
3. Lift the appropriate ink cartridge clamp. Dispose of the
empty ink cartridge properly.
4. Remove the yellow tape seal from the new cartridge and
lower the cartridge into the cartridge holder.
5. Press the ink cartridge clamp down until it locks in place.
c
Caution:
Once you install the cartridges, do not open their clamps
again until you replace the ink cartridges. Otherwise, the
cartridges may become unusable.
-
6. Press the load/eject button again. The printer moves the
print head back to its home position and charges ink in the
system.
c
Caution:
The power light continues to flash while the printer
performs the ink charging operation. Never turn off the
printer while the
result in incomplete charging of ink.
Note:
Even if you do not press the
print head back to its home position about 60 seconds after you
replace the cartridge.
-
load/eject button for three seconds, the
power light is flashing. Doing so can
-
load/eject button, the printer moves the
power
Troubleshooting
6
6-29