Digital wireless weather station with wind speed sensor (19 pages)
Summary of Contents for Taylor 1383
Page 1
Get actual current temperatures and predict the weather conditions for the next 24 hours as well as your local television weatherperson! Taylor uses the temperature and changes in relative humidity levels to forecast the upcoming day. Plan the day with confidence with Taylor Today’s Weather.
Page 2
Set Current Weather Conditions 1. After battery installation, the current weather icon flashes. 2. Press “Up” or “Down” to select the weather icon you believe most closely reflects the current conditions in your area. (Partly Cloudy is the default setting). 3.
Page 3
4.The selected weather icon appears on all screens. (The temperature and forecast readings update after remote sensor is added.) Install Batteries into Remote Sensor *Important: Install the remote sensor batteries after installing the base unit batteries for proper signal connection. Remote sensor –...
Set Up Remote Sensor 1. After installing the batteries into the base unit and the remote sensor, place the units close together for best setup connection. 2. Press the “SYNC” button on the back of the base unit to send a transmission signal to the remote sensor.
Page 5
Only the current temperature will update during first 6 hours. Temperature forecasts and weather icons stay identical while analyzing 1st forecast. 5. After the first 6 hours, when the units begin to forecast weather conditions, all temperature and weather screens will update with new forecasts.
Page 6
To Set Clock and Date 1. Press and hold “TIME/DATE” for 2 seconds, then release. 2. Press “UP” or “DOWN” to change the hours. Press “TIME/DATE”. 3. Press “UP” or “DOWN” to change the minutes. Press “TIME/DATE”. 4. Press “UP” or “DOWN” to switch between a 12 or 24 hour clock. Press “TIME/DATE”.
Additional Features °C/°F Selection Press the “C/F” button on the back of the base unit to switch between Fahrenheit and Celsius temperatures. Backlight Press the Backlight button on the top of the base unit. The LCD screen will light up for approximately 5 seconds. Low Battery Warning Base unit –...
Page 8
Tips (continued) Important: Though the remote unit is weather resistant, it should be placed away from direct sunlight, rain, snow and should never be sub- merged in water. Note: The effective range is greatly affected by the building materials and where the base and remote units are positioned. Try various set ups for the best results.
Problem Solving 1. If the LCD readout is faint, replace the batteries. 2. If outdoor temperature does not display on the base unit: a) Press the “SYNC” button to trigger a signal from the base to the remote; b) Relocate remote sensor if it is obstructed from weather condi- tions or in contact with an object that might affect tempera- ture readings (hot metal object, snow, etc.) c) Remove and reinstall all batteries, using new fully charged...
Page 10
Transmission Information The remote sensor sends temperature and weather condition information to the base unit. After installing batteries into both units, allow 6 hours to analyze weather conditions and report forecasts. Weather readings will update as follows: • Current temperature updates approximately every 1 minute. •...
Page 11
Precautions 1. Always read the instruction manual before operating this product. 2. The base unit is intended for indoor use only. It is not sealed against moisture and could be damaged if used outdoors. 3. Do not immerse the base unit in water. If you spill liquid on it, dry immediately with a soft, lint-free cloth.