To install a DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 18.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and
disconnect the AC power cord.
3. Remove the computer's cover and locate the DIMM sockets (see Figure 14).
4. If a full length PCI Express* graphics card is installed in the PCI Express* x16 connector,
remove the card to gain full access to the DIMM sockets.
5. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the open
position.
6. Holding the DIMM by the edges, remove it from its anti-static package.
7. Position the DIMM above the socket. Align the small notch at the bottom edge of the DIMM
with the keys in the socket (see inset in Figure 14).
8. Insert the bottom edge of the DIMM into the socket.
®
Intel
Server Board S1200KP Product Guide
Installing and Replacing Server Board Components
Figure 14. Installing a DIMM
29