Installing A Disk Drive In The Horizontal Position - Epson EQUITY 386SX/16 PLUS User Manual

Installing a Disk Drive in the Horizontal Position

Before you perform the following steps, be sure that you have
set the jumpers on any hard disk drive(s) that you'll be using.
(If not, see "Setting the Hard Disk Drive Jumpers" on page
B-4 for instructions.)
If you are adding a 3M-inch diskette drive or hard disk drive,
you need to make sure that 5%-inch metal mounting frames
are attached to the drive so it fits properly in the drive bay.
Epson 3 'h-inch drives come with mounting frames already
installed. If your drive did not come with frames installed,
follow the instructions in the manual that came with it to
attach them.
The illustrations in this section show a diskette drive, but
you can use the same instructions to install a hard disk drive.
Follow these steps to install a disk drive:
1. If you are installing a 5%inch diskette drive, turn it so
that the diskette release latch is above the diskette slot.
If you are installing a 35%inch diskette drive, turn it so
that the diskette release button is on the right and the
drive light is on the left.
If you are installing a hard disk drive, turn it so that the
side with the components is facing down.
Installing and Removing Disk Drives
B-33