Setting The Run Time Parameters - Epson EQUITY 386SX/16 PLUS User Manual

Setting the Run Time Parameters

The tests you select will run in the following manner unless
you change the run time parameters:
device.
If you want to change the default run time parameters, press
to move to the Run time parameters window. (Press
F2
any time to exit and return to the submenu of diagnostic
tests.)
The first run time parameter specifies the mode in which to
run the test. You see this prompt:
Testing mode: (T)imebound / (C)ontinuous /
(P)assbound ? P
In Timebound mode, the program runs the tests for the
amount of time you specify; press
In Continuous mode, the tests run until you interrupt them;
press C and
In Passbound mode, the program runs the tests the number
of times you specify. This is the default setting; press
necessary, and
The next option is:
Wait on error (Y/N) ? Y
Press Y, if necessary, and
pause when an error occurs. This lets you view the error
message, make note of it, and then press
(Y is the default setting.)
Performing System Diagnostics
C-4
Enter.
to select the mode.
Enter
Enter
and then
T Enter.
if you want the program to
to continue.
Enter
.
at
Esc
if
P,