Audio Set Menu - Sony PMW-F3L PMW-F3K Operating Instructions Manual

CAMERA SET
Menu items
Horizontal Inv.
Setting the image
inversion function
Lens IF
Selecting the lens
interface

AUDIO SET Menu

AUDIO SET
Menu items
Audio Input
Setting for audio
inputs
106 Setup Menu List
Subitems and setting values Contents
On / Off
Type C / Type A / Off
Subitems and setting values Contents
TRIM CH-1
–20 dBu to –65 dBu (–41 dBu)
TRIM CH-2
–20 dBu to –65 dBu (–41 dBu)
Limiter
On / Off
MIC AGC
High / Low
AGC Link
Linked / Separated
1KHz Tone
On / Off
Wind Filter CH-1
On / Off
Wind Filter CH-2
On / Off
EXT CH Select
CH-1
CH-1/CH-2
Set to "On" to horizontally invert the image.
Select the appropriate lens interface in advance before
attaching a lens.
Type C: For lenses with a Cooke-type connector and those
supplied with the PMW-F3K
Type A: For lenses with a ARRI-type connector
Off: For other lenses
Finely adjust the sensitivity of channel 1 of microphone input
in steps of 3 dB in Manual audio adjustment mode.
Finely adjust the sensitivity of channel 2 of microphone input
in steps of 3 dB in Manual audio adjustment mode.
Turn the audio limiter on/off.
Select the sensitivity of the microphone inputs.
Select the gain link condition when the audio level adjustment
is in AGC mode.
Linked: To vary the CH-1 gain and the CH-2 gain in
synchronization.
Separated: To vary the CH-1 gain and the CH-2 gain
independently according to the respective levels.
Turn the 1-kHz reference tone signal on/off.
Turn the wind filter for channel 1 on/off.
Turn the wind filter for channel 2 on/off.
CH-1: To record channel 1 audio input on both channels 1
and 2.
It is recommended to set the AUDIO SELECT (AUTO/
MANUAL) switch and AUDIO LEVEL control for CH-2
(page 53) as well as the above TRIM CH-2 to the same
conditions as those for CH-1.
CH-1/CH-2: To record channel 1 and channel 2 inputs on the
respective channels.