Installation Instructions; Cooktop; Lp Gas; Before You Begin - GE JGP656 Installation And Owner's Manual

Installation instructions.

BEFORE YOU BEGIN

Read these instructions completely and carefully.
Save these instructions for local inspector's use.
IMPORTANT
CODES AND ORDINANCES.
Note to Installer: Be sure to leave these instructions with
the consumer.

FOR YOUR SAFETY

If You Smell Gas:
1. Open windows.
2. Don't touch any electrical switches.
3. Extinguish any open flame.
4. Immediately call your gas supplier.
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
14
–OBSERVE ALL GOVERNING
Parts List

Cooktop

2 twin burner grates
4 burner caps (1 small, 2 medium, 1 large)
Gas pressure regulator with attached 1/2 to 3/8
reducing bushing and 3/8 pipe nipple
2 clamping brackets with screws
Attached 120 volt grounded plug cord
Self adhesive gasket
1/4 x 36 (1)
3/16 x 36 (2)
Downdraft and Blower Unit
JXBA56 motor and blower assembly is required for
both models.
The blower/motor assembly can be located below
the cabinet floor. The assembly will fit between 16
floor joists. Order JXRB57 for indoor remote locations.
– In this installation a transition to 6 round
is required.
The blower motor assembly can also be installed
outdoors. Order JXBC57 for remote blower
installation outdoors.
Downdraft unit
Downdraft stability brackets
Two filters
Tools and Parts Needed
Large flat blade screwdriver
Saw
Carpenter's square
Pipe wrench
Manual gas line shut-off valve
Pipe joint sealant that resists action of LP gas
Ductwork to suit the installation
For flexible connection where local codes permit:
Flexible metal tubing (same 3/4 or 1/2 I.D. as gas
supply line)
Flare union adapter for connection to supply line
(3/4 NPT x 3/4 I.D. or 1/2 NPT x 1/2 I.D.)
Flare union adapter for connection to regulator
(1/2 NPT x 3/4 I.D. or 1/2 I.D.)
For rigid connection:
Pipe fittings as required