Table of Contents
Advertisement
2.
Connecting the SCS.3m
Before you connect power, you will need to remove the SCS.3m Back Panel:
Figure 2.1
2.1
Connect USB
Figure 2.2
2.2
Connect Power
Figure 2.3
To open back, first look for 2 knobs and turn them so that they are
oriented vertically. When booth knobs are turned, remove the back
by pulling the bottom of the panel up. (Figure 2.1)
When the Back Panel is off, you will see the following sockets:
(2) USB type "A" sockets
(1) USB type "B" socket
(1) 8 mm 12 VDC power supply socket
Connect the USB type "B" connector to the SCS.3m USB
"B" socket and the other end of the USB cable to your
computer's USB port. No drivers are required so your
computer should automatically install the SCS.3m.
(Figure 2.2)
Before connecting other devices, connect the SCS.3m to
power using the included wall adaptor. It is important to
always use the wall adaptor when plugging additional
devices to the USB hub. (Figure 2.3)
3
Connecting the SCS.3m
Advertisement
Table of Contents
