Acquiring Heart Rate - Sportline SOLO 915 User Manual

ACQUIRING HEART RATE

ACQUIRING HEART RATE: FINGER TOUCH
Heart rate may be acquired from any operating mode (not in any Setting Sequence).
1. With the watch attached to your wrist,
metal top plate of the watch) with your index finger.
If Heart Rate Sensors are accidentally touched, the watch will automatically attempt to acquire heart rate. If no heart rate is
NOTE:
detected, watch will resume operating mode in approximately 10 seconds. This will not interfere with any timing functions in progress.
You may exit Heart Rate mode at any time by Pressing the Mode, Start/Stop or Reset key.
NOTE:
2. Continue
TOUCHING & HOLDING
3. Once Heart Rate is acquired,
of approximately 5 seconds.
7
SP4964IS03SPO.indd 7 SP4964IS03SPO.indd 7
the
TOUCH & HOLD HEART RATE SENSOR
until heart rate displays.
. Heart Rate will continue to display for a period
RELEASE THE SENSOR
NOTE: The Monitor displays both actual heart rate
(in beats per minute) and percent of estimated
maximum heart rate .
OR
(anywhere on the
7/28/10 3:42 PM 7/28/10 3:42 PM