Epson Twinax C82315 User Manual page 4

FCC COMPLIANCE STATEMENT
FOR AMERICAN USERS
This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to Pan 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment Is operated In a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used In accordance with the
instruction manual, may cause harmful interference in which case the
user will be required to correct the interference at his own expense.
This devise complies with Pan 15 of the FCC Rules. Operation Is
subject to the following two conditions: (1) This device may not cause
harmful interference. and (2) this device must accept any interference
received, including interference that my cause undesired operation.
This digital apparatus does not exceed the Class A limits for radio noise
emissions from digitai apparatus as set out ln the radio Interference
regulations of the Canadian Department of Communications.
Le présent apparell numérique n'émet pas de bruits radioélectriques
dépassant Ies limits applicables aux appareils numériques de Class A
prescrites dans le règiment our le brouillage radioélectrique édicté par
le Ministére des Communications du Canada.
The connection of a non-shielded equipment Interface cable to this
equipment will invalidate the FCC Certification of this device and may
cause lnterference levels which exceed the limits established by the
FCC for this equipment. It is the responsibility of the user to obtain and
use a shielded equipment interface cable with thfs device. When this
equipment is attached to some printers. you should not leave cables
connected to the printer's built-in connectors. See your printer's user's
manual for details.
Changes or modifications not expressly approved by Seiko Epson
Corporation. could void the user's authority to operate the equipment.
FOR CANADIAN USERS
WARNING