Preparing To Install The Interface Card - Epson Twinax C82315 User Manual

If your system
Is...
System 36,
System 38, AS400
and 5294 or 5394
remote controller
System 34 or 5251
m12 remote
controller
You should keep the following in mind when selecting the emulation.
Only the 3812 emulation supports HP laser printer commands.
If you have a choice between the 5224 and 4214 emulations, you should select
4214. The 4214 emulation adds control of the following features: lines per inch,
pitch, graphics, print quality, and single-sheet handling.
If your printer supports Epson Job Language (EJL) commands, do not change the
printer mode using the EJL commands or the command-pass-thru feature while
the interface is installed. Also you may not be able to change the printer mode
using the control panel.
Never select the PostScript™ printer mode while this interface is installed.

PREPARING TO INSTALL THE INTERFACE CARD

Before installing this interface card you may need to set several jumpers,
depending on the following factors:
The type of Epson printer you are using
The type of IBM printer you want the interface to emulate
The type of twin-axial connector your host system uses
and the Epson
printer you are
using is...
9/24/48 element
dot matrix printer
or laser printer
(using ESC/P
c o m m a n d s )
9/24/48 element
dot matrix printer
or laser printer
(using ESC/P
commands)
3
the emulation
you should
select is...
4214
5224
and you
should select
one of the
following
host system
settings
4214 model 2
5224 (2P)
5225 (2P)
5258 (P)