Setting The Attenuation Level Of The Audio Input - Sony UWP-C1 Operating Instructions Manual

Notes on the European model
The reception channels are
divided into four sets.
Select the group number before
selecting the channel number as
follows.
1) While the left two digits are
flashing, select the group
number by pressing the + or –
button.
2) When the desired group
number appears, press the SET
button.
The right four digits start to
flash to allow the selection of
the channel number.
3) Select the channel number by
pressing the + or – button.
Channel
Group
selection
selection
V : + button
Group, channel, and frequency
selection examples for CE62 model are
shown.
4
When the desired channel number
(or frequency) appears, leave the
tuner for about 10 seconds until
the selected channel number (or
frequency) stops flashing and the
selection is stored in memory.
Frequency
selection
v : – button
Notes
• When you are setting the reception
channel, the tuner can be used to
receive signals.
• Do not remove the batteries while
setting the reception channel. If they
are inadvertently removed, re-insert
them immediately and redo the
procedure "Setting the reception
channel" from step 1.
• Make sure that the selected channel
is the same on the transmitter and
tuner being used in the same system.
• If you turn off the tuner and then
immediately turn it on right after
setting the reception channel, the unit
may not operate normally. Wait a
few seconds before turning it on
again.
Setting the attenuation
level of the audio input
The procedure below is the
same for all UWP series
transmitters (UTX-B1/H1).
The attenuation level can be set during
signal transmission.
1
Do the following while there
is no signal transmission.
Turn on the transmitter while
pressing down the SET button,
and press the SET button
repeatedly until the attenuation
level indication appears in the
display section.
39