Table of Contents
Advertisement
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 15.
Setting the RF Output
Power
(RF POWER)
You can set the RF output power.
1 mW (LOW): transmitted by 1 mW
10 mW (MID): transmitted by 10 mW
50 mW (HIGH): transmitted by 50 mW
Notes
• The setting for this function cannot be
changed during actual signal
transmission. To change the setting, turn
off the microphone first. Then, while
holding down the SET button, turn the
Input
Attenuation
(dB)
MIC
0
3
6
9
3 dB steps
18
21
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 15.
Low-cut Filter Setting
The frequency of the low-cut filter can be
set.
22
Setting Menus
power on. And then, change the setting
after the signal transmission has stopped.
• To start signal transmission with the
selected RF output power setting, turn off
the power and then turn it on again.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 15.
Setting the Audio Input
Level
You can set the input level to the analog
head amp.
Press the + or – button repeatedly to select
the appropriate attenuation level.
The reference levels for the various settings
are as follows:
Reference input
Maximum input
level (dBu)
level (dBu)
–52
–16
–49
–13
–46
–10
–43
–7
3 dB steps
3 dB steps
–34
+2
–31
+5
OFF: Turns off the low-cut filter.
20 30 40 50 60 70 80 90 100
120 140 160 180 200 220 (Hz):
Low-cut filter is set according to the
selected frequency.
Using wireless remote control, this function
can be controlled from the receiver and
(LCF)
other devices.
(INPUT LEVEL)
Headroom (dB)
36
Hide quick links:
Advertisement
Table of Contents
