Epson PowerLite Home Cinema 3010 User Manual page 72

3D content does not display or does not display correctly.
■
Press the
necessary.
■
Make sure that you are within the 3D viewing range (see page 12).
■
Check that your video device and media are both 3D-compatible. Refer to the
documentation that came with your video device for more information.
■
Press the
then select
■
Make sure that the
■
If your video device is connected with the WirelessHD Transmitter (PowerLite Home
Cinema 3010e only), see page 75.
Only part of the picture is displayed, or the picture is distorted.
■
Press the
page 27).
■
If the Aspect is set to
the top or bottom section of the screen so that subtitles are visible (see page 53).
■
Check the
■
Use the
Position
■
If you've connected a computer and you see only half the image, make sure the
computer's Dual Display setting is turned off.
■
If part of the image is cut off, reset the projector settings (see page 51).
■
If your video device is connected with the WirelessHD Transmitter (PowerLite Home
Cinema 3010e only), make sure you are within the wireless transmission range (see
page 56).
You're using a computer and no picture appears on the screen.
If you're using a Windows
■
Press the function key that lets you display on an external monitor. It's often labeled with
an icon such as
the key while pressing it. Check your laptop's manual or online help.
Fn
On most systems, the
projector, or display on both at the same time. Allow a few seconds for the projector to
sync up after pressing it.
72
Problem Solving
button on the remote control to switch to 3D viewing mode, if
2D/3D
button on the remote control, select the
Menu
. Make sure that the
3D Format
Inverse 3D Glasses
button on the remote control to select a different aspect ratio (see
Aspect
, you may need to use the
Zoom
to make sure it's adjusted correctly (see page 52).
Overscan
setting to reposition the image on the screen (see page 52).
®
laptop:
, but it may also be labeled
key lets you toggle between the LCD screen and the
Signal
option is selected.
Auto
option is set to (see page 45).
No
Zoom Caption Pos.
. You may have to hold down
CRT/LCD
menu, then
3D Setup
option to see
,