The Installation Space - GE Monogram ZDWT240 Installation Instructions Manual

THE INSTALLATION SPACE

NOTE:
Handle and handle
standoff depth is 1-3/4"
*For a standard installation: The product must be installed
so that the front face will project 1-3/4" forward of adjacent
cabinets. This position will allow a full door swing and prevent
interference with adjacent cabinetry. The opening between
cabinets must be 23-3/4" minimum.
**For a flush installation: Install a 1/2"-wide filler strip on the
hinge side. The filler strip will act as a spacer between the
door case and adjacent cabinets and will prevent interference
with the cabinet door swing. Recess the filler strip 1-3/4" back
from the front face of the unit, or even with the front edge
of the product case (behind the gasket). The width of the
opening must be 24-1/4" (including the 1/2" filler strip).
• The wine reserve and beverage center can be installed
freestanding.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical must
be located on rear wall as shown. NOTE: GFI (ground
fault interrupter) is not recommended.
Design Guide
THE INSTALLATION SPACE (cont.)
CABINET
These products will fit flush
to adjacent cabinets when
installed with a 1/2" filler panel
or cleat. The filler panel should
be recessed or set back behind
the door and even with the front
edge of the product case.
In a standard installation,
the product will project 1-3/4"
forward of adjacent cabinets.
3
Flush
Installation
Filler panel or cleat
to be set back even
with front of case.
Front edge of product case
Front face
120°
Standard
Installation
CABINET
Front edge of product case
1-3/4"
Front face
120°
1/2"
CABINET
110°
CABINET
110°