STEP 2 LEVEL
• Use an adjustable wrench to turn the leveling legs and
raise or lower the product.
• Adjust carefully; the product should be level and plumb
with cabinetry, and should align with adjacent toekick
height.
STEP 3 CONNECT POWER
• Connect power cord plug to a properly grounded
receptacle.
• Check to make sure power is on by opening the door
to see if interior light turns on.
Installation Instructions
6
STEP 4 SLIDE PRODUCT INTO
THE CUTOUT
WARNING:
push against the glass door when moving or installing
these products. Pressure against the glass door will
cause damage.
AVERTISSEMENT :
jamais et ne mettez jamais de pression sur la porte
en verre quand vous déplacez ou installez ces
produits. Toute pression sur le verre occasionnera
des dommages.
• Carefully slide the unit into the opening. Be careful
not to entangle power cord.
• Make certain that the door protrudes 1" beyond
the surrounding cabinets.
• Check again to be sure the unit is level.
STEP 5 CHANGE THE TOEKICK
• The stainless steel toekick is secured to the back
of the product or inside.
• The toekick has a cutout
on the left and right
sides. Remove
the plug on
the left side
and reinstall
on the right
side. If you
choose to
install the
stainless
steel toekick,
reinstall the plug
on the right side
of that toekick.
• Install original screws and spacers or screws and
spacers supplied with the stainless steel toekick. Install
screws through the spacer standoff, toekick and into
the base as shown.
STEP 6 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to the
Owner's Manual for more information. Allow 24 hours
for temperature to stabilize.
Do not apply pressure or
Ne poussez