Installation Instructions - GE PWS06D Series Owner's Manual & Installation Instructions

Beverage center & wine chiller
Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION SPACE
The beverage center and wine chiller can be a
free-standing model or it can be built in using the
cut-out dimensions below.
Locate
Outlet
12" Min.
34-1/2"-35"
24" Min.
Product dimensions:
Height: 33-3/4" (85.72 cm)
Width: 23-2/5" (59.44 cm)
Cut-out dimensions:
Width: 24" (61 cm) minimum
The cutout depth should be 24"
The cutout dimensions shown allow for a full
door swing and access to the pull-out racks
cabinets.
surrounding cabinets.
wide filler strip or side panel may be needed on
hinge side. The filler strip will act as a spacer
between the case and adjacent cabinet door
swing. The width of the opening must include the
filler panels. NOTE: The door should protrude
• The beverage center and wine chiller can be
installed freestanding.
Additional Specifications
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical
must be located on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not
recommended.
12

Installation Instructions

24"
23-1/4"
23-2/5"
GROUNDING THE BEVERAGE
CENTER AND WINE CHILLER
WARNING
Hazard.
For personal safety, this appliance
must be properly grounded.
The power cord of this appliance is equipped
with a three-prong (grounding) plug which mates
with a standard three-prong (grounding) wall
Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
33-3/4"
properly grounded.
Where a standard 2-prong wall outlet is
encountered, it is your personal responsibility
and obligation to have it replaced with a properly
grounded 3-prong wall outlet.
THIS APPLIANCE.
REMOVE PACKAGING
1
• Remove all packing material, tape and protective
plastic coverings.
WARNING
parts not used.
2
REMOVE RUBBER PAD AND
SHIPPING BRACKET
• Remove Toekick by removing 3 screws.
Electrical Shock
Small objects are a choke
Screws
49-1000514 Rev. 1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pvs06b series

Table of Contents