Installation Instructions - GE GWS03ADWSS Owner's Manual And Installation

Installing the wine chiller.
To raise the wine chiller
Screw
Door
Handle
4
Removing the Packaging
Before using the wine chiller, be sure all packing materials and tape have been
removed, including the protective film covering the control and any film protecting
the cabinet.
If you are discarding an old refrigeration product, remove the doors to reduce
the danger of children being trapped inside.
Installation Guidelines
s The wine chiller can be freestanding
or can be installed under the counter,
with proper clearances.
s Allow the following clearances for ease
of installation, proper air circulation
and electrical connections:
Each side 1/2" (12,7 mm)
Top 2" (51 mm)
Back 2" (51 mm)
s Before connecting the appliance
to the power source, let it stand upright
for approximately 2 hours. This will
reduce the possibility of a malfunction
in the cooling system from handling
during transportation.
Leveling Legs
Adjustable legs at the front corners
of the wine chiller should be set so the
wine chiller is firmly positioned on the floor,
with a 1/8" tilt to the back to help the door
closure.
To adjust the leveling legs, turn the legs
counterclockwise to raise the wine chiller,
clockwise to lower it.
Door Handle
The door handle and screws are shipped
in a hardware bag attached to one
of the shelves inside the cabinet.
Locate the door handle and two screws.
Secure the door handle to the side
of the door as shown.
s Do not install the wine chiller where
the temperature will go below 55°F
(12,7°C) or above 90°F (32,2°C).
If the room temperature is below
the temperature setting, the wine chiller
will not operate (for instance, if the room
is at 55°F (12,7°C) and the setting is 60°F
(15,6°C), the unit will not run).
s Install it on a level floor.
s
Do not install the wine chiller where
it will be subject to direct sunlight,
heat or moisture.
s Do not store or install this appliance
outdoors.