Table of Contents
Advertisement
RiNSiNG
WiTH THE PRESSURE
WASHER
WARNING
Be extremely careful if you
must use the pressure washer from
ladder, scaffolding or any other relatively
unstable location. Pressure in a running
washer builds in the wand as you climb.
When you press the trigger, the recoil
from the initial spray could force you to
fall, or if you are too close to the cleaning
surface, high pressure could force you
off a climbing apparatus.
•
Hook up the water supply and start your pressure
washer (see TO START THE PRESSURE
WASHER).
,
Slide adjustable nozzle back to high pressure
position and wait for detergent to clear, Detergent
will not flow when in the high pressure mode.
When detergent has cleared you may want to
expand the spray pattern for a more gentle rinsing
action. Start at top of area to be rinsed, working
down with same action as for cleaning.
You can also stop detergent from flowing
by simply
removing siphon from bottle.
HOW TO USE ADJUST
PRESSURE
USING
THE PRESSURE
CONTROL
}(NOB
....
Located on the pump is a pressure control knob, You
can increase and decrease the pressure of the spray
by turning the knob clockwise or counterclockwise
respectively. The knob is set at maximum pressure at
the factory.
HOW TO USE THE TURBO
NOZZLE.
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern. This increases the cleaning
effectiveness
of the high pressure spray, Attach the
turbo nozzle on the end of the nozzle extension.
The high pressure spray is most effective when the tip
of the wand is held between 8 to 24 inches from the
surface being cleaned.
Important: The turbo nozzle produces an extremely
high pressure spray which is capable of removing
paint and cutting holes through surfaces if held too
close, Always make sure the surface you will clean will
not be damaged by the high pressure spray.
HOW TO USE THE ROTATING
BRUSH
Your pressure washer comes equipped with a rotating
brush. Use the brush to clean especially dirty surfaces.
It is a soft bristle brush with feathered ends that will
not scratch surfaces.
To connect the rotating brush to the spray gun:
*
Attach the accessory adapter to the rotating brush,
-
After attaching the accessories adapter onto the
rotating brush, attach the accessory adapter to the
nozzle extension,
o After attaching the accessories adapter onto the
nozzle extension, attach nozzle extension onto
spay gun,
Note: The rotating brush operates in low pressure
setting allowing you to dispense chemical with the
brush.
8
Advertisement
Table of Contents
