Table of Contents
Advertisement
CARTON
CONTENTS
The following parts are shipped loose with your
pressure washer:
•
Main Unit -- pressure washer with wheels,
guide handle.
o
High Pressure Hose
o
Parts Box #1 (which includes items listed below)
•
Rotating Brush
,
Vehicle/Boat
Wash
House/Multi-purpose
Wash
o
Parts Box #2(which includes items listed below)
Adjustable Nozzle
o Turbo Nozzle
•
Spray Gun
Nozzle Extension
Wire Form
o Motor Oil
,,
Rotating Brush Adapter
,_ Manual Bag (which includes the items listed
below)
o Owner's Manual
- Nozzle Cleaning Kit
, "O"-Ring Kit
Become familiar with each piece before assembling
the Pressure washer. Check all contents against the
illustration on Page 6. if any parts are missing or
damaged, call the Pressure Washer Helpline at 1-800-
222-3136.
TO REMOVE
PRESSURE
WASHER
FROM
CARTON
Remove parts boxes included with pressure
washer. The high pressure hose is packed in the
bottom of the carton. Remove the hose.
Slice two corners at handle end of carton from top
to bottom so the panel can be folded down flat.
•
Raise handle, secure in place with the locking caps
and roll the pressure washer out the open end of
the carton.
Locking Caps
HOW TO SET UP YOUR PRESSURE
WASHER
For the most part, your Craftsman High Pressure
Washer has been assembled at the factory. You must,
however, attach the wire form, assemble the spray gun,
and attach the high pressure hose to the pump and
spray gun.
While facing the rear of the Pressure Washer,
insert the wire support with the longer arm
positioned on the left. From this view the hook
should resemble a "J'L
!
"I
o
Cut tie wrap on chemical injection tube. Remove
chemical injection filter, thread chemical injection tube
through the wire form and reinsert filter into tube.
Check carton for additional loose parts.
Advertisement
Table of Contents
