Craftsman 580.762201 Operator's Manual page 5

Cutthetiewrapsonthehighpressure h oseand
connect highpressure h osetogun.Tighten by
hand.
Placeassembled s praygunonholder.
® Place turbonozzle in grommet h oleinbase.
Remove plastic capandconnect h ighpressure
hoseto pump. T ighten by hand,
AttachHigh
Pressure
hosehere
Attachnozzle extension tospraygun.
Attach adjustable n ozzle tothenozzle extension.
CHECKLIST
Before you operate your new high pressure washer
please review the following checklist:
o All assembly instructions have been completed.
= The high pressure hose connections to the spray
gun and to the pump are tight and secure.
While learning how to use your high pressure
washer, pay extra attention to the following important
item:
Engine oil is at proper level
_mportant: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure, See
Page 9 for instructions on adding oil and proper oil
specifications,
important: The water supply to your pressure washer
must be connected and turned on prior to starting your
engine.
Be sure gas tank is filled properly with clean, fresh,
unleaded gasoline.
* Become familiar with all controls - their location
and function. Operate those controls before starting
the engine.
5