Assembly - Craftsman 315.115122 Operator's Manual

CHARGING
A HOT BATTERY PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Sears
Repair Center for checking or replacing.
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "CHARG-
iNG A COOL BATTERY PACK" for normal recharging
of batteries. If the charger does not charge your battery
pack under normal circumstances, return both the battery
pack and charger to your nearest Sears Repair Center for
electrical check.
TO INSTALL BATTERY PACK
See Figure 3.
B Place battery pack in your tool. Align raised rib on
battery pack with groove inside tool.
B Make sure the latches on each side of the battery
pack snap in place and battery pack is secured in tool
before beginning operation.
TO REMOVE BATTERY PACK
See Figure 3.
! Locate latches on side of battery pack and depress to
release battery pack from the tool.
B Remove battery pack from the tool.
LOADING THE TOOL WITH STAPLES
See Figures 4 - 5.
B Remove battery pack from the tool.
B Hold tool upside down, squeeze latch, and slide base
open.
B Place staples in channel, legs facing upward, and close
base.
B Make sure the latch is securely locked in place•
B Reattach battery pack to tool.
CAUTION: When placing battery pack in the tool,
be sure raised rib on battery pack aligns with groove
inside tool and latches snap into place properly.
Improper assembly of battery pack can cause
damage to internal components.
LATCH
BATTERY
•PACK
Fig. 4
STAPLES
11
Fig. 5