Craftsman 247.28883 Operator's Manual page 11

Figure3
3. Placethe steering wheel cap over the centerof the steeringwheeI
and push downwarduntil it "clicks"into place.
Attaching The Seat
Ifthe seat for your tractor was not attached at the factory, referto the
following steps.
NOTE: For shipping reasons, seals are either fastened to the tractor
seat's pivot bracketwith a plastic tie, or mounted backwardto the pivot
bracket, In either case, free the seat from its shipping positionand
remove the adjustment knob from the bottomof seat before proceed-
ing withthe instructions below.
1. Position the shoulder screws (found on the base of the seat)
inside the slot openings inthe seat pivot bracket.
Fig. 4.
2. Slide the seat slightly rearward in the seat pivot bracket, lining
up the center rear slot inthe pivot bracket withthe remaining hole
in the sears base.
\
1
Figure 4
3. Selectdesired position forthe seat, andsecure withthe adjustment
knob removedeadier.
4, Toadjustthe positionofthe seat,loosenthe adjustmentknobon the
bottom of the seat. Slide the seat forward or backwardas desired.
Fletightenthe adjustment knob.
Tire Pressure
pressure should be maintained at all times. Neverexceedthe
maximum inflationpressure shown on the sidewall of the tire.
The recommended operatingtire pressure is:
Approximately10 psi for the reartires
Approximately 14 psi for the front tires
IMPORTANT: Referto the tire sidewall for exact tire manufacturer's
recommendedor maximum psi. Do not overinflate.Uneventire pres-
sure could cause the cutting deck to mow unevenly.
11