Craftsman 580.752820 Operator's Manual page 14

For general rinsing (medium pressure and
medium flow), ideal for most all purpose cleaning
such as home siding, brick patios, wood decks,
driveways and sidewalks, garage floors, etc.,
select orange general ProjectPro
TM
nozzle.
For maximum rinsing (higher pressure and
lower flow), for stubborn or hard to reach
surface such as second story surfaces, paint
removal, oil stains, rust removal or other
stubborn substances (tar, gum, grease, wax,
etc.), select red max ProjectPro
TM
nozzle.
4. Pull back on collar, insert selected ProjectPro
TM
nozzle and release collar. Tug on ProjectPro
TM
nozzle to make sure it is securely in place.
5. For most effective cleaning, keep ProjectPro
TM
nozzle from 8 to 24 inches away from cleaning
surface. If you get the nozzle too close, you may
damage the cleaning surface.
6. DO NOT get closer than 6 inches when cleaning tires.
How to Use the HydroFoam
TM
Launcher
The quick-connect on the nozzle extension allows you
to attach the HydroFoam
TM
launcher. Use the
HydroFoam
TM
launcher to apply HydroFoam
TM
wash
or other project specific cleaners to help break down
stubborn dirt and grime on a variety of surfaces,
Follow these instructions to attach the HydroFoam
TM
launcher:
1. Engage trigger lock on spray gun.
2. Pull back collar on quick-connect and pull current
ProjectPro
TM
nozzle off. Store ProjectPro
TM
nozzles in holder provided on the accessory tray.
3. Pull back on collar, insert HyrdoFoam
TM
launcher
and release collar. Tug on HyrdoFoam
TM
launcher
to make sure it is securely in place.
IMPORTANT: Also see the HydroFoam
TM
launcher
and wash instruction sheet for important instructions
and uses.
Cleaning and Applying Detergent
IMPORTANT: Use detergents designed specifically
for pressure washers. Household detergents could
damage the pump.
CAUTION
Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
Up to three (3) different solutions can be carried with
the cleaning system at one time. To apply detergent
follow these steps:
1. Review ProjectPro
TM
nozzle and HydroFoam
TM
launcher use.
,
3.
Pour detergent into one of
the tanks labeled A, B, C.
Prepare HydroFoam
TM
wash or detergents as
required by manufacturer.
Fill cleaning tank(s) with prepared detergents as
needed.
System
Rinse Tank
NOTE: Each cleaning tank holds two quarts.
4. Rotate the Dial-A-Cleaner
TM
selector knob to letter
corresponding to desired tank.
5. Make sure HyrdoFoam
TM
launcher is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (Yellow, Orange or Red).
6. Make sure garden hose is connected to water inlet
and water supply is turned on. Check that high
pressure hose is connected to spray gun and
pump; start engine.
14