Download Print this page

Craftsman 315.114610 Operator's Manual page 5

3/8 in., 18 volt cordless drill-driver variable speed / reversible

Advertisement

_.
WARNING:
Read and understand
all instructions.
Failure to
follow all instructionslisted below, may result in electric
shock, fire and/or serious personal injury.
Never usea battery that has been dropped or received
a sharp blow. A damaged battery is subject to explosion.
Properly dispose of a dropped battery immediately. Fail-
ure to heed this warning can result in serious personal
injury.
Save these instructions. This manual contains impor-
tant safety and operating instructions for charger.
Before using battery charger, read all instructions
and cautionary markings in this manual, on battery
charger, and product using battery charger. Following
this rule will reduce the risk of electric shock, fire, or
serious personal injury.
CAUTION:To reduce risk of injury, charge only nickel-
cadmium type rechargeable batteries. Other types of
batteries may burst causing personal injury and dam-
age. Following this rule will reduce the risk of electric
shock, fire, or serious personal injury.
Do not expose charger to wet or damp conditions.
Following this rule will reduce the risk of electric shock,
fire, or serious personal injury.
Use of an attachment
not recommended
or sold by
the battery charger manufacturer may result in a risk
of fire, electric
shock, or injury to persons.
Following
this rule will reduce the risk of electric shock, fire, or
serious personal injury.
To reduce risk of damage to charger body and cord,
pull by charger plug rather than cord when discon-
necting charger.
Following this rule will reduce the risk
of electric shock, fire, or serious personal injury.
Make sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage or
stress. Following this rule will reduce the risk of serious
personal injury.
Do not abuse cord. Never carry tool by cord or yank
it to disconnect
from
receptacle.
Keep cord from
heat, oil and sharp edges. Following this rule will reduce
the risk of electric shock or fire.
An extension cord should not be used unless abso-
lutely necessary.
Use of improper extension cord could
result in a risk of fire and electric shock. If extension cord
must be used, make sure:
a. That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
b. That extension cord is properly wired and in
good electrical condition; and
c. That wire size is large enough for AC ampere
rating of charger as specified below:
Cord Length (Feet)
25'
50'
100'
Cord Size (AWG)
16
16
16
Note: AWG = American Wire Gage
Do not operate charger with a damaged cord or plug.
If damaged, have replaced immediately by a qualified
serviceman.
Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
Do not operate charger if it has received a sharp blow,
been dropped, or otherwise
damaged in any way; take
it to a qualified
serviceman.
Following this rule will
reduce the risk of electric shock, fire, or serious personal
injury.
Do not disassemble
charger; take it to a qualified
serviceman when service or repair is required. Incor-
rect reassembly may result in a risk of electric shock
or fire. Following this rule will reduce the risk of electric
shock, fire, or serious personal injury.
To reduce the risk of electric shock, unplug charger
from outlet before attempting
any maintenance
or
cleaning. Turning off controls will not reduce this risk.
Following this rule will reduce the risk of electric shock,
fire, or serious personal injury.
Disconnect charger from power supply when not in
use. Following this rule wilt reduce the risk of electric
shock, fire, or serious personal injury.
Save these instructions.
Refer to them frequently
and
use them to instruct
others who may use this tool. If
you loan someone this tool, loan them these instruc-
tions
also. Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
WARNING:
Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemi-
cals known to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals
are:
lead from lead-based paints,
crystalline silica from bricks and cement and
other masonry products, and
arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter
out microscopic particles.
SAVE THESE INSTRUCTIONS
5

Advertisement

loading