Advertisement
Filter Assembly
1. Carefully
slide the filter over the filter
cage,
sliding it over the center
ring cov-
ering the 3 slots until the filter stops
against
the lid.
2. Place
the hole in the filter plate over
threaded
screw
of the filter cage.
3. Gently
push on the filter plate to seat
the rubber
ring of the filter inside the cir-
cular channel
of the filter plate.
4. Place filter nut onto threaded
screw and
tighten
it down.
Finger tighten
only.
NOTE:
Lever of filter nut should
be away
from plate as shown.
IMPORTANT:
Do not overtighten
as this
may deform
or crack the filter plate, filter
cage or the filter.
NOTE:
Your filter has a red stripe
that
matches
an in-store
displayer.
When
you
visit your local Sears
store, just remember
the color of your stripe for the correct
size
filter.
Vac Assembly
1. Locate
the lid assembly
and the drum/
caddy assemblies
(assembled
earlier).
2. Position
the lid assembly
with the inlet
of the unit located
in line with the drain
cap and the drum
label on the vac.
Allow the assembly
to rest on the vac
drum.
3. Rotate
both latches
down until you hear
the latches
snap over the lip of the
drum.
NOTE:
For best appearance
of the unit,
the inlet of the vac should
be located
above
the drain.
Cord Storage
Simply
wrap the power
cord around
the lid
assembly
and snap
the connector
on the
plug to a wrap
of the cord.
_
_"'-"
Filter Nut
__-'-
Filter Plate
Filter
Red
Stripe
Threaded_,_
I
Screw
_.-_
Lid
_r_
_r''_
Filter
\
Caoe
Latch
Latch
Advertisement
