Advertisement
Accessory
Caddy Assembly
1. Unlatch
the drum latches
on the front
and rear of unit. The drum latches
hold
the lid onto the drum.
Lift the lid off the
drum.
Place the lid upside
down on a
clean smooth
surface.
2. Flip the drum upside
down on the floor.
3. Take the accessory
caddy
and position
it on the vac drum. The open
end of
horseshoe
shaped
caddy
should
be
positioned
under the drain cap.
4. Slide the caddy down onto the drum,
the open
end of the caddy
has two
dovetail
slides
that will press
into the
molded
area of the drum.
The caddy
will press onto the drum
until it rests
against
the first step of the drum. The
bottom
edge of the caddy will be even
with the bottom
edge of the vac drum.
If
it is not even with the bottom
of the
drum, tap the edge
until it is flush with
the drum bottom.
The tab lock located
at the rear of the caddy
will latch into
the recessed
area at the rear of the vac
drum.
Accessory
Dove
Caddy
Tail
Orain
Cap
To Install the Wheels/Casters
1. Locate the two 5-1/4"
wheel assemblies
and the single
wheel
casters.
2. Insert
the single
wheel
casters
into the
bottom
of the accessory
caddy as
shown
(2 places).
3. Push on the caster
until the end of the
caster
stem is inserted
all the way into
the socket.
You will be able to hear the
end of the caster snap into the socket
of
the caddy.
The caster
will rotate
easily
when positioning
is correct.
4. Position
the dovetail
section
of one of
the wheel
assemblies
into the acces-
sory caddy as illustrated.
Tap the wheel
support
of the assembly
with a soft mal-
let if necessary.
Repeat
for the second
wheel
assembly.
5. Flip the drum/caddy
assembly
upright
with the wheels
of the caddy
resting
on
the floor.
NOTE:
When
emptying
debris
from the
wet/dry
drum, it is not necessary
to
remove
the vac caddy.
Advertisement
