Storage; Adjust Engine Speed - Sears Craftsman 536.884561 Owner's Manual

o Pushthesparkplug'wireontothe spark
plug.
• Reinstall t hetop cover.
ENGINE SERVICE
Unless the operator is fully qualified to
make engine repairs or adjustments, we
recommend that such work should be done
by technicians trained to work on snow
thrower type engines, Take your snow
thrower to your nearest SEARS Service
Center for repair and adjustment.
ADJUST ENGINE SPEED
Your engine speed has been factory set. Do
not attempt to change engine speed or it may
result in personal injury. If you believe that
the engine is running too fast or too slow, take
your snow thrower to your nearest SEARS
Service Center for repair and adjustment.
Z_ WARNING: Never store your snow
thrower indoors or in an enclosed, poorly
ventilated area_ if gaso!ine remains in the
tank, fumes may reach an open flame,
spark or pilot light from a furnace, water
heater, clothes dryer, cigarette, etc.
To prevent engine damage (if snow thrower
is not used for more than 30 days) follow
the steps below.
SNOW THROWER STORAGE
- Thoroughly clean the snow thrower.
• Lubricate all the lubrication points. See
the Maintenance section, page 10.
• Be sure that all nuts, bolts and screws are
securely fastened. Inspect all visible
moving parts for damage, breakage and
wear. Replace if necessary.
• Touch up all rusted or chipped paint
surfaces; sand lightly before painting
. Cover the bare metal parts of the blower
housing and auger with rust preventative,
such as a spray lubricanL
ENGINE STORAGE
Gasoline must be removed or treated to
prevent gum deposits from forming in the
tank, filter, hose, and carburetor during
storage. Also during storage, alcohol
blended gasoline that uses ethanol or
methanol (sometimes called gasohol)
attracts water° It acts on the gasoline to
form acids which damage the engine.
• To remove gasoline, run the engine until
the tank is empty and the engine stops_
Then drain remaining gasoline from
carburetor by pressing upward on bowl
drain located on the bottom of carburetor°
See next figure.
Carburetor
Bowl Drain
Right side view of
engine
o If you do not want to remove gasoline, a
fuel stabilizer (such as Craftsman fuel
stabilizer No. 33500) may be added to
any gasoline left in the tank to minimize
gum deposits and acids° If the tank is
almost empty, mix stabilizer with fresh
gasoline in a separate container and add
some to the tank. Always follow instruc-
tions on stabilizer container. Instructions
on stabilizer container. Then run engine
at least 10 minutes after stabilizer is
added to allow mixture to reach carbure-
tor. Store snow thrower in a safe place.
See Warning under STORAGE.
OTHER
° If possible, store your snow thrower
indoors with the gas removed and cover it
to give protection from dust and dirt
• If the machine must be stored outdoors,
block up the snow thrower to be sure the
entire machine is off the ground.
t5
L