Irregular Or Curved Shaping - Sears 113.239201 Owner's Manual

IRREGULAR OR CURVED SHAPING
A variety of shapes may be produced with the shaper by
changing the the height of cutter in relation to the
workpiece, by using various combinations of cutters on
successive passes, and/or by inverting cutter and changing
direction of spindle rotation and feed direction. The table
insert must be removed if the cutter does not clear the hole
in the insert when the cutter is lowered below the table
surface: check clearance before turning switch "ON":
1. To make irregular shaping cuts remove power cable
from electrical source, remove the fence assembly,
select the shaper collar that will position the cutter to
obtain the desired pattern, and lock the shaper collar
and cutter on the spindle,
NOTE: A shaper collar may be located above or below
a cutter, or between the two cutters selected.
[ ( ° SPINDLE NUT
"ljj wAs,,R \ .
OF "° _ -,, ...,.__ SPACER _. I
SHAPER COLLAR
(OPTIONAL
ACCESSORY)
O
O
SHAPER COLLAR SET
(OPTIONAL ACCESSORY)
2. Mount the cutter guard and adjust as shown.
Position the Guard verticatlV (A) (Guard should just
clear workpiece)
Center the Guard over the cutter. (B)
NOTE: Rotate cutter by hand and check for proper
clearance inside guard.
f
STARTIN G J
17