Installing Shaper Fence; Installing Shaper Cutter Guard - Sears 113.239201 Owner's Manual

INSTALLING SHAPER FENCE --
FOR STRAIGHT EDGE SHAPING ONLY
Install the fence with two 5/16-18 x 2 inch hex head
screws and two plain washers. These screws thread into
tapped holes in the table, Adjust the fence as outlined
on page 13.
FENCE
5/16-18 X 2 IN,
HEX HD. SCREWS
AND WASHERS
GUARD SUPPORT
INSTALL! NG SHAPER CUTTER GUARD -
FOR CURVED OR IRREGULAR SHAPING ONLY
NOTE: Fence must be removed.
1. Assemble Cutter Guard as illustrated.
]/4-28 LOCI(NUT
L.H, SUPPORT
t
Align the guard support so that it is centered on the shaper
spindle (it may be necessary to loosen the 5/t6-18 screws
which secure the support bracket to the channels to
perform this adjustment). After the alignment is achieved
tighten all four screws securely.
install Cutter Guard Assembly to table support using the
two 5/t6-18 × 2 inch hex head screws located at rear of
table support,
11