Straight Edge Shaping; End Shaping With Use Of Miter Gauge And Hold-Down Clamp - Sears 113.239201 Owner's Manual

A'JX
WC_KPIECE
27 IN;
STRAIGHT EDGE SHAPING
CAUTION: The Shaper fence must be used in all straight
edge shaping operations.
I; When shaping stock 3 inches wide or _ess, an auxiliary
fence/work Support must be used as shown.
2. Make the push stick as shown.
SLIGHTLY:THICK'ER
THAN WORKPlECE
PUSH STICK
(FEEDS UNDER
AUXILIARY FENCE/
WORK SUPPORT
AUXILIARY FENCE/ \
WORK SUPPORT
SLIGHTLY THINNER AND
NARROWER THAN WORKPIECE
FENCE
N
2O
WORKPIECE
PUSH STICK
END SHAPING WITH USE OF MITER GAUGE AND
HOLD-DOWN CLAMP (OPTIONAL ACCESSORIES)
1. NEVER use the Miter Gauge on the Shaper without the
Hold-down Clamp installed and the workpiece clamped,
2, Both fence faces MUST be positioned so the workpiece
cannot contact them.
3, Adjust the head of the miter gauge so the end of the
workpiece to be shaped wil! be exactly parallel to the
miter gauge slot in the table, This holds true for all
angles of the end of the workpiece,
4. The board is positioned in the miter gauge; then hold
:::the w0rkpiece firmly against the miter gauge head and
:doWn on the table with your left hand, and feed by
::gripping the lock handle with your right hand.
/:i::::::i:: i/5 ;:::i:i: i i
<. :;, ¸:¸7:¸ i ¸ •
t6