Sears 113.239201 Owner's Manual page 18

3. The starting pin must be used asa pivot to support the
work untillit has been :fed intothe :s_a_r col ari:Tlie
Starting:Pin may the:i:tw6
threaded holes "ear:the' table insert:oPening;: depending
upon i the: direction 0f :r0tatloni:: buti_aiways 0_ :the
in-feed side;
4,
WARNING: DO NOT ATTEMPT TO SHAPE WARPED
LUMBER.
Workpiece MUST contact the FRONT of the cutter and
collar L_ toward the miter gauge slot.
5_ In addition, the following operations are some which
performed::or_: the shaper - shaping with a
pattern, l,t0ngue and groove joints, reading and fluting,
etc:. (" Power Tool Know How" Handbooks are
available ).See Recommended Accessories st.
NOTE:I After a few hours of operation, tighten both pulley
t screws securely with the Hex wrenches provided.
PIVOT WORKP|£CE
AROUND STARTING PIN
18