Gardena 4000/4 1482 Operating Instructions Manual page 7

Pump constantly cuts in Leak on the pressure side.
and out without drawing
water.
There being deposits of dirt in
in Electronic Manometric Switch.
Pump does not cut out. Rotary switch / non-return
valve is set to position 2.
Non-return valve of the Electronic
Manometric Switch is blocked.
Larger leaks on the pressure side.
Pump doesn't start Outlet end (e.g. water accessory)
working. is closed. There is sufficient water
pressure in the pressure line.
If you have any problems with Note : The pump can also be
your Pressure Tank Unit, please operated without the Electronic
contact our Service or return Manometric Switch
the defective unit together with a ging the mains plug for the pump
F
short description of the problem – into the mains socket. If the
in case of guarantee, with a copy fault is caused by the Electronic
of the receipt – postage paid to Manometric Switch, then it is
one of the GARDENA Service sufficient to forward this to the
Centres listed on the back of this appropriate servicing office.
leaflet.
20
line and fill antiliming agent or a
mixture of water and vinegar into
the pump using the delivery outlet
6
. Afterwards rinse thoroughly.
Check the pressure line and
connected consumers for leaks.
The non-return valve shall be at
position 1 when localising faults.
Note : Even the smallest leak
(loss of a few mls) can cause the
pressure in the pump to drop.
The cause of this is often small
leaks at taps and toilet flushing
cisterns.
Loosen the Electronic Mano-
metric Switch from the pump.
C
Turn the non-return valve
position 2.
Clean the non-return valve, e.g.
by flushing in the direction of flow.
Set the rotary switch to posi-
tion 1.
Clean the non-return valve, e.g.
by flushing in the direction of flow.
Rectify leaks.
Open the outlet end.
We expressly point out that,
in accordance with the product
5
by plug- liability law, we are not liable
for any damage caused by our
units if it is due to improper
repair or if parts exchanged are
not original GARDENA parts
or parts approved by us, and if
the repairs were not carried out
by a GARDENA Service Centre
or an authorised electrician.
The same applies to spare
parts and accessories.
G
EU Certificate of Conformity
The undersigned
GARDENA Kress + Kastner GmbH · Hans-Lorenser-Str. 40 · D - 89079 Ulm
hereby certifies that, when leaving our factory, the units indicated below are in accordance with the
harmonised EU guidelines, EU standards of safety and product specific standards.
This certificate becomes void if the units are modified without our approval.
Description of the units :
Pressure Tank Unit
Types :
4000 / 4 electronic plus
4000 / 5 electronic plus
Art. nos.:
1482 / 1484
to
EU directives :
Machinery Directive 98 / 37 / EC
Electromagnetic Compatibility
89 / 336 / EC
Low Voltage Directive 73 / 23 / EC
Directive 93 / 68 / EC Year of CE marking :
Directive 2000 / 14 / EC 1996
Harmonised
European standards : Ulm, 21.02.2002
EN 292 -1
EN 292 - 2
EN 60335 -1
EN 60335 - 2 - 41 Thomas Heinl
Technical Dept. Manager
Noise level :
measured / guaranteed
1482 77 / 78 dB (A)
1484 79 / 80 dB (A)
G
21