Assembly; Unpack The Pressure Washer; Carton Contents; Assembling Cleaning System - Craftsman 580/752352 Operator's Manual

Your c leaning system requires some assembly andisready
foruse onlyafter i t hasbeen properly serviced withthe
recommended oilandfuel.
If you have any problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
UNPACKTHE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handlewith CleaningTank Assembly
• Accessory Tray
• High Pressure Hose
• Spray Gun
• NozzleExtensionwith Ouick Connect Fitting
• HydroFoam
TM
Wash
• Oil Bottle
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Safety Goggles
• Bagcontaining 3 multi-colored ProjectPro
TM
Nozzles
• HydroFoam
TM
Launcher
• HydroFoam
TM
Launcher & Wash Instruction Sheet
• FreshStart Fuel Cartridge
• HandleFasteningHardwareKit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLINGCLEANIHG SYSTEM
Your Craftsman cleaning system wiil need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connectwater supply to pump.
8. Attach nozzleextension to spray gun.
9. Select/attach quick connect ProjectPro
TM
nozzleto nozzle
extension.
Attach Handle and Accessory Tray
1. Placehandle assembly onto handle supports connected
to main unit. Make sure holes in handle align with holes
on handle supports.
Handle
Supports /
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of unit
and attach plastic knob from inside of unit. Tighten by
hand.
%.
3. Placeaccessory tray over holes on handle (viewing from
front of unit). Push tree clips into holes until they sit flat
against accessory tray.
4. Insert multi-colored ProjectPro
TM
nozzlesand other
supplied accessories in spaces provided in accessory
tray. See "How to Use Accessory Tray".