Operating Controls; Auger Control - Craftsman 247.88790 Owner's Manual

Read thisowner's manual andsafetyrules before operating y oursnow thrower. C ompare F igure 13below withyour
snowthrower t ofamiliarize y ourself w iththelocation ofvarious controls a ndadjustments. Savethismanual for
future reference.
Drive Control
Shift Lever
Four-Way
.,_"
Chute ControFM
/.,
Auger Control
Headlight
Fuel Tank
Wheel Steering
Control
Chute Assembl_.
Clean-Out Tool
\.
\
Muffler
\_ Spark
\
Carburetor \
Cover \
\\
Oil Fill
Fuel Cap
1
Electric
Shave Plate
/,
Auger
/
Ignition
Key .... l_
Choke
_Starter
Handle
"_ Primer
Shoe Control
Oil Drair¢
Figure 13
Operating Controls
(See Figure 13 )
Drive / Auger Control Lock
The drive control is located on the right handle.
Squeeze down the drive control to engage the wheel
drive. Release to stop.
The drive control also locks the auger control so you
can operate the chute directional control without
interrupting the snow throwing process. If the auger
control is engaged simultaneously with the drive
control, the operator can release the auger control (on
the left handle) and the augers will remain engaged.
Release both controls to stop the augers and wheel
drive.
IMPORTANT: Always release the drive control before
changing speeds.
Auger Control
The auger control is located on the left
handle. Squeeze the auger control to
engage the augers. Release to stop the
snow throwing action. The drive control
must also be released in order to stop
the auger.
IMPORTANT: Refer to Auger ControlTeston page 7 prior
to operating your snow thrower. Read and follow all
instructions carefully and perform all adjustments to
verify your snow thrower is operating safely and
properly.
Ignition Key
The ignition key must be inserted and snapped in place
in order for the engine to start. Remove the ignition key
to prevent unauthorized use of equipment. Do NOT
attempt to turn the key.