Craftsman 247.88790 Owner's Manual page 6

Figure 4
IMPORTANT: Make certain that all three flange
keepers are securing the chute base lip to the chute
assembly. See Figure 5.
7.
8.
Figure 5
Pull the hairpin clip out of the clevis pin on the chute
support tube. Save both pins.
Place the 4-way chute control in a centered
position. See Figure 6.
i i
Figure 6
9. Insert the round end of the chute control box on the
short tube of the chute assembly as shown in
Figure 7.
10. Insert other end of the chute control box into the
chute support tube. See Figure 7.
Figure 7
11. Insert the clevis pin, earlier removed, through the
holes on the chute control box and chute support
tube. Secure with the hairpin clip. See Figure 8.
Figure 8