Craftsman 172.10721 Owner's Manual page 7

BEFORE YOU BEGIN TO WAX, BUFF AND POLISH YOUR CAR:
1. Wash, clean and dry your vehicle.
2. Remove all road tar, excess grease spots and bug stains with a
general-purpose cleaner.
3. Make sure the work area is dry.
ATTACHING THE WAX APPLICATOR BONNET TO THE FOAM PAD
(See Figure 2)
WARNING: When changing accessories, ._ j/
BE SURE that the switch is in the (OFF) Fig. -_
position and the cord is unplugged.
1. Place wax applicator bonnet on foam pad
as shown in Fig. 2.
2. ALWAYS make sure that the elastic strip
on the bottom of the bonnet is securely
tucked on the underside of the foam pad.
APPLYING WAXTO BONNET (See Figures 3 and 4)
IMPORTANT: DO NOT APPLY WAX
DIRECTLY ON CAR! Fig. 3 _
APPLYING PASTE WAX TO BONNET
(See Figure 3)
1. Spread a heaping teaspoon of wax
evenly over entire surface of applicator
bonnet using a putty knife or any other ____j/°
flat object (See Fig. 3).
APPLYING LIQUID WAXTO BONNET
(See Figure 4)
1. Apply three swirls of wax over applicator
bonnet (See Fig. 4).
2. This should be enough to cover 1/4 of
car surface.
3. For the second and third applications,
only use about one half as much as on
first application. The bonnet will not
absorb as much wax on these
applications.
Fig. 4
7