Craftsman 172.10721 Owner's Manual page 9

APPLYING WAX ONTO SURFACE TO BE POLISHED cont. (See Figure 9)
9. Shut "Off" the buffer/poisher when
you have finished applying wax with
applicator bonnet.
10, Remove the wax applicator bonnet
and use it to hand polish all the
hard-to-reach surfaces (under
bumpers, around door handles, etc.).
(See Figure 9.)
11. Properly dispose of wax applicator
bonnet.
ATTACHING THE POLISHING BONNETTOTHE FOAM PAD
(See Figure 10)
WARNING: When changing accessories,
BE SURE that the switch is in the
(OFF) position and the cord is unplugged,
1. Place the terry cloth bonnet on foam
pad as shown in Fig. 10.
2. ALWAYS make sure that the elastic
strip on the bottom of the bonnet is
securely tucked on the underside of the
foam pad,
BUFFING AND POLISHING - REMOVING THE WAX FROM THE SURFACE
(See Figure 11)
NOTE; Remove wax in the same order
as it was applied.
1. Place extension cord over your shoulder.
2. Turn buffer/polisher "On".
3. Buff and polish (remove wax) when it
has dried to an even haze.
NOTE; For best results, use long,
sweeping strokes in a criss--cross pattern
when removing wax.
_> <Ej;£-iiiiiiiiii:.:.
4. Buff and polish the entire surface until all dried wax is removed, Remove the
bonnet from time to time and shake out the dried wax residue. A bonnet with
excess residue will cause streaking. You may need to replace the bonnet with
a new one if you can't get it clean enough to avoid streaking.
5. Use a clean terry cloth bonnet for final buffing and polishing. Or use a foam
polishing bonnet (sold separately) for the ultimate "showroom shine
9