Craftsman 211420 Assembly Instructions And Parts List page 2

16,NEVER
LEAVE A RUNNING TOOL UNATTENDED,
Turn the power switch to the "OFF" position, DO
NOT leave the tool until it has come to a complete
stop,
17, DO NOT STAND ON A TOOL, Serious injury
could result if the tool tips over or you accidentally
contact the took
18, DO NOT store anything above or near the tool where
anyone might try to stand on the tool to reach it,
19, MAINTAIN YOUR BALANCE. DO NOT extend
yourself over the tool, Wear oil resistant rubber°
soled shoes, Keep floor clear of debris, grease,
and wax,
20, MAINTAIN TOOLS WITH CARE, Always keep tools
clean and in good working order, Keep all blades
and tool bits sharp,
21, EACH AND EVERY TIME, CHECK FOR DAM-
AGED PARTS PRIOR TO USING THE TOOL,
Carefully check all guards to see that they operate
properly, are not damaged, and perform their
intended functions, Check for alignment, binding or
breaking of moving parts, A guard or other part that
is damaged should be immediately repaired
or replaced,
22, CHILDPROOF THE WORKSHOP AREA by
removing switch keys, unplugging tools from the
electrical receptacles, and using padlocks,
23, DO NOT OPERATE TOOL IF UNDER THE
INFLUENCE OF DRUGS OR ALCOHOL,
24, SECURE ALL WORK, When it is possible, use
clamps or jigs to secure the workpiece, This is
safer than attempting to hold the workpiece with
your hands,
SAVE THESE iNSTRUCTiONS.
UNPACKUNG AND CHECKUNG CONTENTS
This Bench Grinder Leg Set wiii require a minimal
amount of assembly, Use a rubber mallet or a hammer
with a wooden block for assembly,
Remove all of the parts from the shipping box,
Check and clean each part and lay them on a clean
work surface, Compare the items and quantities to
Figure 1-1,
CAUTION: if there is any missing or damaged parts,
do not attempt to assemble this Bench Grinder Leg Set,
To obtain missing or damaged parts, please call
1 °800°897°7709,
Figure 1-1
\
\
KEY PART
NO, NO, DESCRmPTION
1 OR93517 TRAY
2 STD52320 HEX HD SCR 5/16-18 X 2" (not shown)
3 STD551031 FLAT WASHER 5/16" (not shown)
4 STD551131 LOCK WASHER 5/16" (not shown)
5 STD541031 HEX NUT 5/16-18 (not shown)
6 OR93518 UPPER LEG
7 OR93519 LOWER LEG
8 OR93520 SHORT HORIZONTAL SUPPORT
9 OR93521 LONG HORIZONTAL SUPPORT
10 OR90394 FOOT
O:0
QTY, 1
2
4
2 7
2
4
4
2
2
4