Assemby; Carton Contents; Attaching Handle; Adding Engine Oil - Craftsman 580.752330 Owner's Manual

Yourpressure washer requires s omeassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withtherecommended oil andfuel.
If you haveanyproblemswith the assemblyof
your pressurewasher,pleasecallthe pressure
washerhelpIineat 1-800-222-3136.
REMOVE PRESSURE WASHER
FROM CARTON
• Slice two corners of carton from top to bottom so
the panel can be folded down flat.
• Remove fillers, accesories and parts bag shipped
with your pressure washer.
• Roll pressure washer out open end of carton.
• Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
• The main unit
Handle
Accessory tray
Spray gun
High pressure hose
Nozzle extension with quick connect fitting
Turbo nozzle
Engine oil
Parts bag (which includes items listed beJow)
• Owner's manual
• Registration card
• Bag containing 4 multi-colored ProjectPro
TM
nozzles
• Fresh Start
TM
fuel cartridge
• Handle fastening hardware kit (which includes):
• Carriage bolt (2)
• Plastic knobs (2)
• Tree clips (4)
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 5. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Fill out and send in registration card.
2. Attach handle.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect nozzle to nozzle
extension.
Attach Handme
1. Place handle onto handle supports connected to
main unit. Make sure holes in handle align with
holes on handle supports.
\
, !
Handle /
Align Holes _-_p _/>
Handle i
// Supports /
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit.
Tighten by hand.
3. Place accessory tray over holes on handle
(viewing from front of unit). Push tree clips into
holes until they sit flat against accessory tray.
ii i
i i
/
Jm J
ii
4. Insert multi-colored ProjectPro
TM
nozzles and
other supplied accessories in spaces provided in
accessory tray. See "How to Use Accessory Tray".
Add Engine Oi_
CAUTRON! Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
1. Place pressure washer on a level surface.
2. Clean area around oil fill and remove oil dipstick.
3. Using oil funnel (optional), slowly pour entire
contents of provided oil bottle (18 oz.) into oil fill
opening.