Table of Contents
Advertisement
BELT INSTALLATION
-
1. Carefully
work new belt down between
transaxle
belt keepers
and onto the
input pulley.
2,
Slide belt into the center span keeper.
3.
Pull belt toward front of tractor and roll
around the top groove
of engine pulley,
4.
Install belt through
stationary
idler and
clutching
idler.
5.
Make sure belt is in all pulley grooves
and inside all belt guides
and keepers.
6.
Install mower (See "TO INSTALL
MOWER"
in this section
of manual).
TO ADJUST
STEERING
WHEEL
ALIGN-
MENT
If steering
wheel crossbars
are not
horizontal (left to right) when wheels are
positioned straight forward,
remove steer-
ing wheel and reassemble
with crossbars
horizontal.
Tighten securely.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not
adjustable on your tractor. If damage
has
occurred to affect the front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO REMOVE WHEEL FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheels have a square key - Do not
lose).
3. Repair tire and reassemble.
NOTE: On rear wheels only: align
grooves in rear wheel hub and axle. Insert
square key.
4. Replace washers and snap retaining
ring securely in axle groove.
5. Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, purchase and
use tire sealant from Sears. Tire sealant
also prevents tire dry rot and corrosion.
TO START ENGINE
WITH A WEAK
BATTERY
_WARNING:
Lead-acid
batteries
gen-
erate explosive gases.
Keep sparks, flame
and smoking materials away from bat-
teries. Always
wear eye protection when
around batteries.
If your battery
is too weak to start the
engine, it should be recharged.
(See "BAT-
TERY" in the MAINTENANCE
section of
this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
Your tractor is equipped
with a 12 volt system. The other vehicle
must also be a 12 volt system. Do not use
your tractor battery
to start other vehicles.
TO ATTACH JUMPER
CABLES
-
1. Connect
one end of the RED cable
to the POSITIVE
(+) terminal
of each
battery(A-B),
taking care not to short
against
tractor chassis.
2.
Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal
(C) of
fully charged
battery.
3,
Connect
the other end of the BLACK
cable (D) to good chassis
ground,
away from fuel tank and battery,
TO REMOVE
CABLES,
REVERSE
ORDER
-
1. BLACK
cable first from chassis
and
then from the fully charged battery.
2.
RED cable last from both batteries.
Weak or Dead
Fully Charged
Battery
Battery
Washers
Retaining
Ring
Axle
Cover
Square Key
..._'
(Rear Wheel Only) _
24
Hide quick links:
Advertisement
Table of Contents
