Complete Installation; Range Hood Use; Range Hood Controls - IKEA Range Hood Installation And User Manual

Secure the bottom of the duct with 2 - 4.2 x 8 mm T20 ®screws
using a T20 ®Torx ® drive (or T20 ®adapter provided) to tighten.
1. For non-vented (recirculating) installations only, install
charcoal filters over metal vent filter. See the "Range Hood
Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light. See
the "Range Hood Use" section.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
A
A. 4.2 x 8mm T20®screws
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The range hood controls are located on the front side of the
canopy.
@@@@@
A B C D E
A. Light On/Off button
B. Blower On/Off button
C. Blower speed minimum button
D. Blower speed medium button
E. Blower speed maximum button
NOTE: Control buttons will light up when range hood is On.
Operating the light
The Light On/Off button (A) controls both lights. Press once for
On and again for Off.
Operating the blower
D
E
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct covers
C. Lamp housings
F
D. Canopy
E. Grease filter
F. Grease filter handle
G. Control panel
The Blower On/Off button (B) turns the blower On or Off. The
Blower Speed buttons (C, D and E) set the desired speed and
control the sound level for quiet operation. The speed can be
changed anytime during fan operation by pressing the desired
blower speed button.
1. To turn the blower On, press the Blower On/Off button (B) and
the desired speed button (C, D or E).
2. To turn the blower Off, press the Blower On/Off button (B).
Any of the 3 blower speed buttons can be in the On position at
the same time. The blower will operate at the highest speed
button that is pushed in. For lower blower speeds, the higher
speed buttons must not be pushed in.
11