Intel YM430TX User Manual page 25

3. Parallel Printer Connector (26-pin block)
This connector supports the included parallel port ribbon cable and mounting
bracket. Connect the ribbon cable to this connection, and mount the bracket to
the case on an open slot. Enable the parallel port and choose the IRQ through
Onboard Parallel Port in Chipset Features of the BIOS software. (Pin 26 is
removed to prevent inserting in the wrong orientation when using ribbon cables
with pin 26 plugged).
Parallel (Printer) Connector
4. Serial Port COM1 and COM2 Connectors (two 10-pin blocks)
These connectors support the provided serial port ribbon cables and mounting
bracket. Connect the ribbon cables to these connectors, and mount the bracket to
the case on an open slot. Enable the serial port and choose the IRQ through
Onboard Serial Port in Chipset Features of the BIOS software. (Pin 10 is re-
moved to prevent inserting in the wrong orientation when using ribbon cables
with pin 10 plugged).
Onboard Serial Port Connectors
Pin 1
Connect the Red stripe to Pin 1
For this connector to be available, you must connect
the included Parallel (25-Pin female) cable set to a
free expansion slot opening.
TIP: You may also remove the bracket
connectors and mount them directly to
the case to save expansion slot space.
COM 1 For these connectors to be available,
you must connect the included serial
cable set from COM1 (using the 9-Pin
Pin 1
male) & COM2 (using the 25-Pin male)
to a free expansion slot opening.
COM 2
TIP: You may also remove the bracket
connectors and mount them directly to
Pin 1
the case to save expansion slot space.
Intel YM430TX User's Manual 25