Location Requirements; Window Installation; Remove Packaging Material - Frigidaire FRA08EZT1 Installation Instructions Manual

NOTE:
available from your dealer or service center. See "Accessories."
Do not use any screws other than those specified here.

Location Requirements:

IMPORTANT:Observe all governing codes and ordinances. Check the location where air conditioner will be installed.
Proper installation is your responsibility. Make sure you have everything necessary for correct installation.
Grounded electrical outlet within 4 ft (122 cm) of where the power cord exits the air conditioner.
Free movement of air in room to be cooled.
A large enough opening for the air conditioner.
Adequate wall support for weight of air conditioner. Air conditioner weights between 70 and 85 Ibs (32 to 40 kgs).
NOTE:
Do not use an extension cord.
Cabinet louvers must not be obstructed. Air must be able to pass freely through the cabinet louvers.(FIG.1)

Window Installation:

Window opening measurements (FIG.2) :
A

Remove packaging material:

Remove and dispose of / recycle packaging materials. Remove tape and glue residue from surfaces before installing
the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
Handle the air conditioner gently.
1． Remove the air conditioner from the carton and place it on cardboard.
2. Remove 1 shipping screw from each side of the cabinet (FIG.3).
3. Remove front panel by removing 1 Phillips screw from each side of the front panel. Set screws aside and save
(FIG.4).
4. Pull on the handles to slide the air conditioner out of the cabinet. Place the air conditioner on cardboard (FIG.5).
2
Installation Instructions
FIG.1 FIG.2