Musical Fidelity M1CDT Compact Disc transport Instructions For Use Manual page 8

1
2 3 4
1 DISPLAY
2 POWER ON/STANDBY button
3 - PLAY/PAUSE button
►|▐▐
4 - STOP button
█
5 - Track back button
▐◄◄
10 11 12
10 COAXIAL (RCA) digital output
11 OPTICAL (TOSLINK) digital output
12 AES/EBU (XLR) digital output
M1 CDT manual issue 2
FACILITIES & CONNECTIONS
5 6 7 8 9
6 - Track forward button
►►▌
7 - EJECT button
▲
8 IR RECEIVER lens
9 CD SLOT
13 14 15
13 TRIGGER (3.5mm jack) input
14 TRIGGER(3.5mm jack) output
15 MAINS INPUT (IEC)
Page 8 of 17
If REPEAT is then pressed whilst in shuffle mode, machine reverts to repeat mode, cancelling shuffle function
PLAY
repeat
Pressing | selects the next track in random order.
►►
SCAN INTRODUCTION
The scan-introduction function allows play back of just the start of each track on the disc, for instance to locate a
preferred track by ear.
Press INTRO on the remote control, and if the player has stopped, the display will show
STOP
scan disc
The first ten seconds (approximately) of each track on the CD can then be played in sequence by pressing
either on the front panel, or on the remote control.
►|▐▐ ►
Press INTRO again to cancel introduction search mode. If INTRO mode is cancelled while the M1CDT is still
playing, the remainder of the entire disc will be played.
PROGRAMMED PLAY
The built-in program memory allows you to store up to 30 track numbers and then play them back in the held
order. Each track is stored as a "step" in the program.
With the CD loaded and the player stopped, first press PROGRAM on the remote control. The following is then
displayed:
STOP.
program 01 tr 01
On the remote control, press the numeric button of the track number corresponding to the first track you wish to
store (number 3 for example). That track number will now appear in the display:
STOP.
program 01 tr 03
If a second digit is required for the track number, it may be pressed directly after the first. When the track
number is correct, press PROGRAM again on the remote control - the next program step is selected, (program
2) and the program number increases, ready for a new entry with previous programmed track number still
displayed.
STOP.
program 02 tr 03
Continue entering track numbers in the same way up to a maximum of 30. If more than 30 tracks are attempted
the memory will not accept any extra ones, and the display reverts to "PROGRAM 1".
M1 CDT manual issue 2
OPERATION
OPERATION
7 0:39
74
74
74
74 72:36
Page 13 of 17