Vchannel 4 Timer Control Output; Wpower On Memory; Programming; For Standard Remote Transmitter - Auto Page C3-RS-727A LCD Operation Manual

U. CHANNEL 3 (TRUNK RELEASE) OUTPUT.
Press and hold button on the transmitter for two seconds
to remote control the trunk release or other electric devices.
(If Installed as an Available Option)
V. CHANNEL 4 TIMER CONTROL OUTPUT
Press the transmitter (4) and
same time to active Channel 4 function. Channel 4 is
user-programmable timer output. You may program the
built-in timer to send a ground signal for any time duration
from 1 second to 120 seconds. For instance, this timer
output may be used to turn on the headlight, power
window or sunroof. (Factory defaults setting at momentary
output.)
W. POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to remember its
alarm state if the po wer is lost and then reconnected.
X. SECOND VEHICLE SECURITY OPERATION:
Your 5-button remote transmitter can be utilized to control a second vehicle security
system, To program the remote control transmitter to a second vehicle, follow the
instructions fo r Transmitter programming.
Programming the Transmitter to 2
Enter:
1. Turn the ignition key ON 3 times. (Finishing in the ON position)
2. Press valet switch 2 times, holding in on the 2
chirp. (Release the valet switch)
3. Press the shift button of the Car 2 transmitter.
* The standard transmitter (II) is shift button.
** LCD transmitter must be put in 2
4. Press the lock button on the transmitter; you will hear 1 siren chirp.
Turn OFF the ignition switch; you will hear 3 long siren chirps to confirm
programming and exit transmitter programming
*

For Standard Remote Transmitter:

1. Prior to pushing any button on the transmitter. Press the Select II button first on
the transmitter.
2. Once II button is pressed the LED on the transmitter will illuminate for 3.5
seconds to indicate the second transmitter pin code has built-in.
3. While the LED is illuminated, press any button on the remote control transmitter
to control a second vehicle security system.
**

For 2-way LCD Display Transmitter:

2nd Car Operation:
(4) buttons at the
nd
Car
nd
push, you will hear a long siren
nd
car mode to program for 2
19
nd
car. (See below)