Frpo: Firmware Reprogram - Lexmark MX6500e 6500e Technical Reference Manual

PRESCRIBE commands

FRPO: Firmware RePrOgram

Kyocera printers support a large set of permanent defaults which can be set using the FRPO command. The PRESCRIBE
emulation option supports a subset of the more significant settings. The FRPO INIT command is supported and only
affects the settings in the following table, with the exception of the L parameters. These FRPO settings cannot be set
differently per input port.
Parameter
A1,A2 Top margin
A3,A4 Left margin
A5,A6 Page length
A7,A8 Page width
C1 Page orientation
C3 Default font
L1,L2 Top‑edge limit
L3,L4 Left‑edge limit
L5,L6 Bottom‑edge limit
L7,L8 Right‑edge limit
N4 Duplex binding
P1 Default emulation
P2 Carriage return
P3 Line feed
R3 Use FRPO edge limits and margins
U0 Line spacing
U1 Line spacing
U6 Country code
LA Character centering
LB Memorex font group
LC Use bitmaps if available
LE Paper source for LF/LG offsets
LF Top offset for LE source
LG Left offset for LE source
A1–A8: Margins
FRPO margin settings are always acknowledged in Proprinter and Line Printer emulations. They are only acknowledged
in PCL emulation if parameter R3 is set to 1.
Description Factory default
0,0
0,0
15,0
9,0
0
0
0,20
0,20
10,60
8,10
0
6
1
1
0
6
0
255
1 (Center)
0
0
0
0
0
Notes
Inches
Inches
0 = Line Printer
1 = Proprinter
6 = PCL
PCL‑only setting
Lines per inch (integer value)
Lines per inch (fraction value)
255 = Use panel setting
Lexmark‑only setting
Lexmark‑only setting
Lexmark‑only setting
Lexmark‑only setting
Lexmark‑only setting
Lexmark‑only setting
13